Welder
Name: Enter the welder's first name, middle initial, and last name into their respective fields. Include any applicable suffix (e.g, Jr., Sr., III) in the "Last Name" field.
Stamp Number: Enter the welder’s Stamp number.
Current Status: If a welder temporarily stops working ,change the status to Inactive or Unavailable. Doing so will keep the welder from appearing on Inspection Reports, Welder Qualification Reports, and WPS Qualification Reports. Toggle the display of inactive welders on the Tools > Defaults > Welder tab.
Welder ID: This is a required field. Each welder record must be unique so that the proper record is used throughout the program, therefore each record must have a unique Welder ID. This information may be automatically completed depending upon the settings on the Tools > Defaults > Welder tab.
Hourly Rate: This is not a required field. This field integrates with the Weld Estimation software.
Personal Information
Address
Enter the Welder's address in this section.
Current Status
Active Date: Enter the active date of the welder.
Inactive Date: Enter the inactive date of the welder. By default, inactive welders are not listed in reports. This can be changed in Tools > Defaults > Welder.
Location: Enter the welder's location (e.g., the site name, the city name, etc.). This field can be used to filter and sort the welder data. The label for this field can be changed in Tools > Defaults > Welder.
Foreman: Enter the welder's foreman. This field can be used to filter and sort the welder data. The label for this field can be changed in Tools > Defaults > Welder.
Union Local: Enter the local union number. This field is not required and will not be applicable for all welders.
Common Arc: Select this box to list the welder as a common arc welder. This will allow the welder to be viewed when running the Common Arc Continuity Report.
Welder Notes: Enter additional notes about this welder.
Welder Image: A welder image may be added to the documentation. The image must be added here on the welder information tab before the image can be attached to the document.
 | Load an image into the welder record. |
 | Remove the image from the welder record. |
Related articles