...
Enter any notes to include with the WPQ. In some cases, notes will automatically be inserted in an effort to show limitations that would apply per ASME Section IX (e.g., "Pipe with O.D. ≤ 24" limited to flat rotated only"). Notes such as "n2" refer to ASME Section 9 code.
Test Results
Groove Weld
Bend Tests
Figure No. and Type: Select the figure number and the type of guided bend test from the drop-down list; select None if radiography testing was performed.
Result: Enter the result of the selected test.
Note that as with PQRs matching pairs are generally required. For example 2 QW-462.3(b) Face bends and 2 corresponding QW-462.3(b) Root bends as below. Once an initial ned is inserted the matching (root, side, etc.) will automatically be created and locked.
Typically mismatched bends as below are not allowed by code.
Volumetric test results: If radiography (x-ray) testing was performed, enter the results in this field.
Note that prior to the 2009 ASME Code these were referred to as "Radiographic test results".
Visual examination results: The accessible surfaces of the welds should be examined without magnification for this test.
...