...
Name: Enter the welder's first name, middle initial, and last name into their respective fields. Include any applicable suffix (e.g, Jr., Sr., III) in the "Last Name" field if desired.
Stamp Number: Enter the welder’s Stamp number.
Welder SSN: Enter the Welder’s Social Security Number.
Current Status: If a welder temporarily stops working ,change the status to Inactive or Unavailable. Doing so will keep the welder from appearing on Inspection Reports, Welder Qualification Reports, and WPS Qualification Reports. Toggle the display of inactive welders on the Tools > Defaults > Welder tab.
Welder ID: This is a required field. Each welder record must be unique so that the proper record is used throughout the program, therefore each record must have a unique Welder ID. This information may be automatically completed depending upon the settings on the Tools > Defaults > Welder tab.Hourly Rate: This is not a required field. This field integrates with the Weld Estimation softwareBy default Stamp # and Welder ID are synced but this can be adjusted in Settings.
Hourly Rate: An optional field to store welder's pay rate for cost estimation.
Current Status: If a welder temporarily stops working you can change their status to Inactive or Unavailable. Inactive or Unavailable welders can then be filtered out of reports.
Personal Information
...
Contact Info
Enter the Welder's address, home and mobile phone # and email in this section.
Current Status
...
Inactive Date: Enter the inactive date of the welder. By default, inactive welders are not listed in reports. This can be changed in Tools > Defaults > WelderThis field will only appear for welders marked Inactive or Unavailable.
Location: Enter the welder's location (e.g., the site name, the city name, plant, floor, etc.). This field can be used to filter and sort the welder data. The label for this field can be changed in Tools > Defaults > Welder→ Settings → Welder.
Foreman: Enter the welder's foreman. This field can be used to filter and sort the welder data. The label for this field can be changed in Tools > Defaults > Welder Tools → Settings → Welder.
Union Local: Enter the local union number. This field is not required and will not be applicable for all welders.
Common ArcWeld: Select this box to list the welder as a common arc weld welder. This will allow the welder to be viewed when running the Common Arc Weld Continuity Report if they have applicable qualifications.
Welder Notes: Enter additional notes about this welder.
Welder Image: A welder image photo may be added to the documentation. The image must be added here on the welder information tab before the image can be attached to the document.
 | Load an image into the welder record. |
 | Remove the image from the welder record. |
welder record. Take care in the size of the image as this can bloat databases. We suggest small images (perhaps 80 by 200 pixels) as these images are mainly used to basic identification and on WPQ output.
...
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | |||
|---|---|---|---|
| |||
|