ProWrite automatically assigns a WPS number when the form is entered. You can change this number to any alphanumeric value with a maximum length of 30 characters, or you can leave the automatically generated number. This article explains how ProWrite determines that number.

The automatic WPS numbers reference multiple aspects of the WPS. In the examples above, the numbers have been broken down into their separate parts.

Process Category

If the WPS is for a standard weld, nothing will appear in this section, so the WPS number will begin with the "Process Type" section. The following codes will appear for other welds:

Fw - Fillet Weld
Ov - Overlay
Hf - Hard facing
Stud - Stud Weld
Brz - Braze

Process Type

Up to three symbols will appear for Process Type - one for each process. They will appear in order of process.

• T - GTAW	• S - SAW	• TB - Torch Brazing
• M - SMAW	• P - PAW	• FB - Furnace Brazing
• G - GMAW	• O - Oxy-fuel	• IB - Induction Brazing
• F - FCAW	• EG - EGW	• RB - Resistance Brazing
	• ES - ESW	• DB - Dip Brazing

P-Number

If the P-Numbers are different, there will be two numbers separated by a dash (-), otherwise there will be a single number.

Impact Testing

If impact testing was performed, g will appear in this section. It will be followed by a Group Number or two Group Numbers separated by a dash (-) if the Group Numbers are different.

Post Weld Heat Treatment

If PWHT was performed, H will appear in this section.

Base Metal Thickness

One of the following characters will follow a dash (-) at the end of the WPS number. This indicates the base metal thickness.

a - Less than 5/8 inch
b - 5/8 to 1-1/2 inches (inclusive)
c - Greater than 1-1/2 and less than 2-1/2 inches
d - 2-1/2 inches and over

Related articles

Page:

Program Settings - PQR/WPS
Page:

ASME WPS - Joint Design
Page:

WPS - Welding Procedure Specification
Page:

Creating a Preliminary WPS
Page:

Creating a PQR from a Preliminary WPS

Browser not supported