/
Nozzle - Determining if UG-16 Applies

Nozzle - Determining if UG-16 Applies

Owned by Former user (Deleted)
Last updated: Dec 19, 2016 by Mike Clark

The minimum thickness selection (Vessel Information > General Tab) can be applied to nozzle calculations. Paragraph UG-45 covers the thickness of nozzle necks. If UG-45(b) applies to the nozzle, the minimum thickness per UG-16 does affect the nozzle neck thickness. View the definitions of tb1 and tb2 from paragraph UG-45 in SC VIII-I for more information.


Related content

Nozzle - The Appendix 1-7(b) Rn over R ratio
Nozzle - The Appendix 1-7(b) Rn over R ratio
CEI Knowledge Base
Read with this
Nozzle - Design Information
Nozzle - Design Information
CEI Knowledge Base
More like this
Nozzle - Troubleshooting
Nozzle - Troubleshooting
CEI Knowledge Base
More like this
Nozzle - General Information
Nozzle - General Information
CEI Knowledge Base
More like this
Nozzle - Area of Reinforcement Definitions
Nozzle - Area of Reinforcement Definitions
CEI Knowledge Base
More like this
Nozzle
Nozzle
CEI Knowledge Base
More like this