(Fixed, Floating, and U-Tube)

Perform MDMT Calculations

Perform UCS-66 calculations: Selecting this check box will cause the software to perform UCS-66 toughness calculations on the component. This option is only available to materials that are classified as UCS materials per Table UCS-23.

Exemption Drop-down: When UCS-66 calculations will not be performed (the software will not allow these calculations when a non-UCS material is used), an exemption must be entered. The exemption may be typed in or selected from the drop-down options, but the user is responsible for ensuring that the exemption selected is valid for the material, service, etc., in question.

Related articles

Page:

Tubesheet - Tube
Page:

Tubesheet - Tube to TS Joints
Page:

Tubesheet - Conditions
Page:

Tubesheet - Figures
Page:

Tubesheet - Why are some of my results showing as NC

Browser not supported